top of page
 |
|---|
DIY - instructions for the Flower of Life 3D
​
​
The pictures below will help you assemble your geometry.
​
what do you need:
fast-drying transparent drying wood glue
​
time you need:
about 90 minutes
​
Always check and respect the glue instructions.
​
Good luck!
​
​
​
Pay close attention to the labels on every disc, because there is only one way to put the discs together
​
If some pieces do not stay together at the tabs, you can glue them with wood glue. But only do this only at the end, when you are sure that the form is assembled in the right way.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
What do you need ?
All elements of the geometry:
Make your geometry
Take off the foil carefully.
Step 1:
How it need to be at the end of this step
Bring in carefully and with patience:
On top as well below you need to pass
the connections at the same time.
It can take some tries before it comes
in the right position.
Step 2:
How it need to be at the end of step 2
part 2
part 1
part 1
part 2
Step 3:
